One、What is the price per square meter for exterior wall bricks?
There are many types of exterior wall tiles, and different types and brands will have a certain impact on the price. For example, common exterior glazed tiles and polished tiles typically cost around 20 yuan per square meter, while more design-oriented imitation antique exterior wall tiles and printed exterior wall tiles can cost 30-40 yuan per square meter. This demonstrates that exterior wall tiles can be relatively expensive.
Two. What is the cost per square meter for exterior wall tiles?
When tiling exterior walls, the cost typically varies depending on whether the contractor provides both labor and materials or just labor. The cost for labor and materials generally ranges from approximately 30-50 yuan per square meter, and is primarily determined by the quality of the materials and the construction techniques used. Alternatively, if the contractor only provides labor, the cost ranges from 20-30 yuan per square meter.
III. Exterior Wall Brick Laying Construction Process Flow
1、Substrate preparation
Remove protruding sections from the wall surface, ensuring that the substrate is clean, free of debris, and smooth.
2、Layout and preliminary application
After cleaning the substrate, it is not possible to directly lay the exterior bricks. Instead, you need to first draw several control lines indicating the desired height around the wall using a marker, and then draw a cross on the wall surface to control the size of each tile.
3、Prepare the wall tile adhesive.
Add the appropriate amount of water to the adhesive mixture, mix and stir thoroughly, then allow it to stand for 5-10 minutes before stirring again for 1-2 minutes before use.
4、Install wall tiles
Apply the wall tiles with the slurry-coated back according to the pre-laid pattern. After ensuring a smooth surface, press firmly on the tile surface with your hand to bond it to the wall, and then use a rubber hammer to tap and compact it, enhancing its stability.
5、Gap Filling/Repair
For small gaps or noticeable recesses of 2-3 millimeters in tile joints, it is possible to first fill them with tile joint filler. When preparing coatings, the proportion of the powder component can be increased slightly to improve bonding with the substrate and facilitate application. The coating should be prepared and used immediately.
6、Joint Filling
The joints should be as uniform as possible, and there should be no air bubbles between the tile adhesive and the substrate to ensure a firm bond.
7. Cleaning and Maintenance
After the jointing work is completed (the specific time may vary depending on the weather conditions), and after the mortar has reached a certain strength, the exterior wall bricks should be thoroughly cleaned from top to bottom with water.