One, how to lay matte bricks
There are many ways to layMatte brick, besides the most common method of laying bricks horizontally and vertically, there is also "Letter of Intent" (person-shaped layout), "Self-adhesive patch" (beam-shaped layout), "Diagonal diamond pattern adhesive" (diagonal rhombus pattern layout), "Cut-edge bricks for smaller mosaic pattern" (laying corner bricks with small flower bricks), and "Tile edging installation" (laying floor tiles with edge lines).
This method of application is also favored by homeowners. When installing glossy tiles, the specific application method should be determined based on the overall interior design style of the home to ensure that the entire room maintains a consistent style, creating a more harmonious and aesthetically pleasing living environment.
II. Construction steps for matte bricks
1、Leveling the walls and floors.
Leveling involves preparing the surface of the building before laying the glossy tiles. This includes cleaning the surface to remove any debris and wetting it, followed by mixing cement sand to create a level surface. Typically, a trowel is used to continuously apply the cement sand mixture to maintain a roughly level surface. It is essential to ensure that the cement sand mixture is completely dry before proceeding with the tile laying.
2、Use a string to mark the location of the matte brick.
based on the determined application method, apply color or white wash online, and then draw the location and reference lines for the matte tiles and grout on the leveled surface.
3、Matte bricks fully absorb moisture.
Soak the matte bricks in water to allow them to fully absorb moisture, ensuring that no air bubbles are released. This prevents the matte bricks from reabsorbing water after installation, which could cause them to warp.
4、Mix the cement and sand in a 1:2 ratio.Compatible
The quality of the mixed mortar affects the adhesion of the matte bricks. Typically, the cement-sand mortar should be mixed in a ratio of 1:2. The grade of the mixed cement-sand mortar should be below 200#, which will be applied to the back of the matte bricks.
5、Applying the putty
Remove the pre-soaked matte bricks, wipe off any moisture, and spray enough water onto the leveling layer. Then, apply cement mortar evenly to the back of the bricks, with a mortar thickness of 5-6cm (increase the thickness slightly when laying large-sized matte bricks). Next, place the bricks onto the prepared surface, gently tap them into place with a wooden hammer to ensure they are flush, avoiding air pockets, and always check for levelness with a straight edge.
7、Repair and finishing
After applying a certain area of matte bricks, use putty paste to fill in the joints and level the surface. Additionally, remove any debris (such as cement mortar, water, stains, etc.) from the surface of the matte bricks to enhance maintenance.
III. important considerations for installing matte bricks
1、Construction Sequence
Generally, contractors will first lay the wall tiles and then the floor tiles. This prevents the floor tiles from affecting the wall tiles and delays the construction process. The laying of wall tiles typically starts from the corners or around windows and doors, proceeding in a downward and outward direction, from left to right.
2、Inspect and clean
Before applying the matte tiles, it is necessary to inspect and clean the wall surface. If there are cracks in the wall, they must be repaired first. During the installation of wall tiles, construction teams often apply putty paste to the wall. If the putty paste is not removed, tiles are directly applied, which poses a significant safety hazard.
3、Prepare the substrate in advance.
Before laying the glossy tiles, it is necessary to prepare the substrate properly. If the glossy tiles are laid and then found to have poor alignment or an inconsistent pattern, removing and re-laying them will result in unnecessary waste and loss.