One: What should I do if the custom massage bathtub won't start?
Check if the air ducts for the air switch and motor switch are leaking or not properly connected, and reconnect them if necessary.
Check if the power is connected and turned on. If the power is not connected, please connect it.
Check if the electrical switches are properly installed, and replace any damaged ones immediately.
Inspect the motor switch for damage. You can check this by blowing air into the switch. If you hear a sound when blowing air, it means the switch is functioning properly. If there is no sound, the switch is damaged and needs to be replaced immediately.
Check the motor windings for burnout. If the motor windings are burnt out, the motor must be replaced.
Two. Common Troubleshooting Methods for Jacuzzi Bathtubs
1、The soaking tub is not to be used for water.
Inspect the faucet for any foreign objects obstructing the water flow. If foreign objects are present, clean the bathtub faucet thoroughly.
Inspect the bathtub faucet for any damage and, if any is found, replace it.
2、The jacuzzi exhibits leakage.
Check that the nozzle is properly installed, that the putty application is sealed, and that the nozzle is securely connected to the water pipe. If there is leakage, first disconnect the water pipe and then reconnect it using pipe sealant.
Inspect the faucet valve for damage and check if the sealing ring is cracked; if so, replace it. Also, inspect the faucets on the bathtub for cracks and replace them if necessary.
3、The whirlpool pump motor starts, but does not pump water.
Check if the water level in the massage bathtub has reached the minimum water level. If not, continue adding water.
Inspect the pump impeller in the whirlpool tub for damage or looseness. If damaged, replace it. If loose, tighten it.
Inspect the water pump's inlet pipe for any leaks. If leaks are detected, the pipe should be sealed and tightened.