What should be used to dilute stone adhesive?
1、When diluting stone adhesive, use only water. Do not use other materials, as reactions between substances could lead to undesirable consequences, affecting the use of the stone adhesive and resulting in waste.
2. To accelerate the setting of the stone adhesive, a hardening agent is added during dilution. The typical ratio of hardening agent to stone adhesive is 1:15, which is the ideal ratio, preventing either excessively fast or excessively slow setting, thus saving time.
Methods for diluting stone adhesive
Mix the stone adhesive with water in a 4:1 ratio, and stir until a uniform paste is formed. Allow it to rest and mature for approximately 2-3 minutes, then stir again before use.
Key considerations for repairing and coloring stone joints
1、Environmental Requirements
Light Requirements: When mixing, it is best to do so on a sunny day with ample natural light.
Stone Requirements: When mixing, ensure that the stone is clean and dry, and that its natural color is accurately reproduced.
2- Thorough comparison
The mixing process is not a one-time operation. When mixing, it is essential to first perform tests on a small area. Continuously compare the color with the stone's color, testing incrementally until the desired color is achieved. The final color should be determined only after the stone adhesive has dried, and the color closest to the stone's color should be selected. Do not rush to determine the color before the stone adhesive is dry.
3- Ready-mixed
Due to the trial-and-error nature of the mixing process, there are many uncertainties involved. Even if the same worker mixes the material twice, unpredictable variations can occur. Therefore, for the same area, it is recommended that the same worker mixes the material once to ensure consistency.