One、Are sliding doors operated by a magnetic latch or hydraulic hinges?
Fashion sliding doors typically use hydraulic hinges. These hinges are preferred because they provide cushioning, preventing the door from slamming shut and potentially pinching fingers. They also minimize wear and tear on the door due to inertia. These hinges can be configured for automatic closing or for two-stage cushioning, and some also include a door closer function.
II. Installation and Adjustment Method for Fashion Invisible Door Hydraulic Hinges
1、Pre-installation preparation
Before installation, ensure that the hinges have been adjusted to the minimum closing force position and are in a silent state, which will allow for easy opening of the hinges and facilitate installation.
2、Marking and Positioning
Typically, before installing interior door hinges, installers first align the positioning line with the marked lines and then use a drill or a wood drilling tool to create holes in the door.
3、Tighten screws
Secure screws in the door panel using the pre-drilled holes. Ensure that the screw heads do not protrude from the door panel surface, as this could interfere with the hinges and prevent the door from closing properly.
4、Testing and Evaluation Results
Open and close interior doors to test. Typically, hydraulic hinges can be adjusted in six directions to ensure proper alignment. The gap between the two doors should be approximately 2.5mm on each side.
5. Inspection Usage
After installing the hydraulic hinges, check whether the door leaf opens and closes smoothly without any unusual noises or rebounding. Then, open the door leaf and insert a piece of paper (A4 size) into any potential impact points. Close the concealed door leaf. If the paper cannot be pulled out at any particular location, it indicates that there is an impact point, and the hydraulic hinges should be reinstalled and adjusted.