1. Installation steps for PVC folding door
PVC folding doors are folding doors manufactured using PVC as the main material. These doors offer numerous advantages such as resistance to acids, alkalis, abrasion, and moisture, and are relatively inexpensive, making them widely popular. So, how are PVC folding doors installed?
1. First, install the PVC folding door into the opening, ensuring proper alignment. Then, fold the door leaf into the center of the frame and secure the upper and side walls of the frame with support screws.
2. Using a drill, create 5mm diameter holes at the corresponding positions on the left and right door frames (top, middle, and bottom), approximately 10mm deep, then remove the support screws. This will allow you to remove the PVC folding door from the door opening.
3. Using a 7mm impact drill, create a 5mm diameter hole on the inner side of the door frame wall, with a depth of approximately 40mm. Then, insert the six-hole plugs into each of the above-mentioned holes.
4. Re-install the PVC folding door into the doorway, ensuring the sealing gasket holes are properly aligned. Using a screwdriver, insert and tighten self-tapping screws into the above-mentioned sealing gasket holes to secure the door frame.
5. Open the PVC folding door at the midpoint of the door frame, and tighten the screws in the upper hanging rail slots of the folding door using a reverse-turning action. Insert the retaining plate at the bottom of the folding door where the hinges are located, and tighten the screws.
6. After installation, perform testing by gently opening and closing the door several times. If it functions normally, it is ready for use.
Two. What are some tips for installing PVC folding doors?
When installing PVC folding doors, several techniques can be employed to simplify the installation process and achieve better results. The key techniques for installing PVC folding doors include:
1. Before installation, mark the door frame and measure the track length to ensure it is suitable. If the track is too long, cut off the excess portion with a saw, and then proceed with installation.
2. When inserting the folding door into the track, it should be inserted in its bundled state for easier installation.
3. During installation, first ensure that the handle and the latch are installed in the correct orientation, and then install the track.
4. When tightening screws, ensure they are installed and secured in the correct order, from center to left and right. If drilling into a concrete wall, pre-drill the screw holes in advance.
5. During installation, a magnetic strip can be attached. Align the magnetic strip with the corresponding location on the folding door first, then tighten the screws to secure the strip.