One, install several magnetic locks for the building doors
Installing a magnetic lock on a door can provide anti-theft protection. However, in addition to installing the electronic magnetic lock, other accessories are also required. The following details several accessories that may be used during the installation of an electronic lock.
1、Matching Under-Door Latch for Electrical Locks: An under-door latch is required when the building door lacks a frame. Under-door latches are typically made of aluminum alloy and are directly attached to the door's glass.
2、Compatible with electric lock、Door closer：When the building's entrance features frameless glass on both sides.，Must choose the upper option.、Door closer。Due to the need for secure attachment of the arc chute to the glass surface.，The quality of on-site deliveries must be exceptional.，And it has a large volume.，Typically made of stainless steel.。Also, concurrently，The lower door closer must be compatible with the upper door closer.，Unlike single-door closers, this system…。Ascend、Under-door closers are relatively expensive.。
3、L-shaped brackets for use with magnetic locks: These brackets are often needed when using magnetic locks, particularly for inward-opening doors. They are typically made of aluminum alloy.
4、U-shaped support for use with magnetic locks: When the building door frame is frameless, a U-shaped support must be used. These supports are typically made of aluminum alloy.
5、Cathode lock body compatible with anode lock：This type of lock typically uses mechanical security features.，The latch must not be a square-shaped.。
Two. Installation method for smart locks for stainless steel building doors.
1. First, use a screwdriver to open the cover plate and then use a spanner to tighten the edge board, preparing for installation.
2、Remove the installation board. Fold the board along the indicated lines and place it in the desired mounting location. Then, mark and drill holes in the areas that require them.
3. Insert the hexagonal bolts into the hinge plate, place the rubber bushings between the two metal bushings, and then attach them to the hexagonal bolts. Insert the hinge plate into the three holes drilled in the door, and use the mushroom head from the other side of the door to insert into the corresponding holes. Use a wrench to secure the hinge plate to the door.
4. Secure the edge board to the pre-drilled doorway frame using two semi-circular head screws (inserting them into the long-shaped holes of the edge board). Note: Do not fully tighten the edge board, allowing it to move freely in both directions to facilitate adjustments to the installation position.
5. Follow the instructions in the manual to connect the wiring and cover the cover. Insert the small aluminum column into the screw holes of the lock body. The stainless steel door lock is now installed.