One, repair with wax
If the wooden door has a light color, you can use wax to repair scratches. First, grind the wax into a powder and apply it evenly to the scratches. Then, heat the wax powder on the scratches to allow it to fully melt. After that, remove the wax that has seeped into the scratches, and allow the wax to cool slowly. The advantage of this method is that it is simple and easy to use. However, the disadvantage is that the wax is not hard enough and can easily cause further damage.
Two. Repair using touch-up paint.
Scratched wood door finish, without affecting the underlying wood, can be repaired using wax crayons or touch-up pens that match the color of the original wood door. Apply the repair material to the damaged area, covering the exposed base color. Finally, apply a thin layer of clear nail polish to seal the repair. This method is suitable for those who prioritize ease of application over a perfect finish.
Three. Repair with patching compound.
If the damaged area is not on the surface of the solid wood door, but rather in inconspicuous locations such as edges and corners, you can use materials such as wax crayons, touch-up pens, and repair paste to repair it. If the damaged area is in a very obvious location on the surface, do not use these materials. Using these materials to repair it will not achieve the original appearance of the solid wood door in terms of flatness and gloss.
4. Sand the surface and then repair.
The wooden door surface has significant scratches. First, sand the surface to even it out, starting with coarser sandpaper and then using finer sandpaper. After sanding, ensure that no sanding marks remain. Then, apply the same color spray paint, and finally, apply a transparent, non-glossy spray paint with the same level of gloss to restore the surface to its original condition.
Five. Reapply paint
If the scratches on the solid wood door surface have penetrated the substrate, you can first use a knife to remove the paint near the scratches, then clean the area with steel wool, and then fill it with wood powder and 502 glue or atomic putty. After smoothing, fill in the color and apply a coat of paint.