One, what thickness is required for walls with sliding doors?
The required thickness for installing sliding doors varies depending on the material of the wall.
If installing sliding doors on a gypsum board wall, the wall should be at least 7mm thick. If installing sliding doors on a wall constructed of red bricks and cement-based putty, the wall should be at least 15mm thick. This ensures sufficient space between the door and the wall.
Before installing sliding doors, it is advisable to consult with contractors and build the wall according to the actual situation.
Two. How to handle the edges of sliding doors and walls.
The edges of sliding doors and walls require door trims, which not only enhance aesthetics but also improve the interior's thermal and acoustic insulation performance.
Step 1: Basic Framework
Select solid wood for the core material. Cut the wood planks to equal widths according to the original door frame dimensions to form the basic frame of the door. First, mark a horizontal line on the wall using an infrared level. Then, measure the size of the door opening and draw a perpendicular line on both sides using a plumb bob.
Step 2: Drilling holes in the wall
Drill holes in the wall using an air drill, insert wooden wedges, and be sure to mark the locations. Then, install the door frame in all directions, ensuring that the corners are perfectly square. Next, drive nails through the door frame and into the wooden wedges to secure the frame to the wall.
Step 3: Apply a multi-layer coating.
once the basic door frame has been properly fixed, you can proceed with the multi-level installation. This is done to create a slightly recessed space, typically around 4-5 cm, for easier door operation and closure.
Step 4: Install the panel
After completing the above steps, you can begin installing the panels. First, measure the dimensions accurately, then cut the panels to size. When installing, ensure that the seams are tight and properly sealed.
Step 5: Install wooden battens
once the panels are installed, you can begin installing the wooden trim. Maintain a 1cm gap from the inside out, mark the locations, and then install the cut wooden trim according to these markings. This will enhance the overall appearance of the door frame.Additionally, ensure that there is approximately 5cm of space between the door frame and the floor to allow for subsequent work, such as leveling the floor or installing flooring or tiles.
Step six: Door frame line
Use a nail gun to attach the door frame to the door casing, then secure the door frame and silent strip. This will ensure that the joint between the front and back door frame is properly sealed. Be careful not to drive all the nails in at once, as this could cause the door frame to become misaligned. Then, remove any excess wood with a saw.
Step 7: Surface Cleaning
once the door frame is installed, perform the final cleaning of the wooden door frame surface. This will allow for the installation of the sliding door.