One、How to operate the remote control for electric glass door locks
Button A: Pressing button A will lock the system, disabling the fingerprint and door opening functions. The electric door can only be opened with a remote control.
B Key: Pressing the B key will close the door. It also releases the lock (which was locked by pressing the A key).
C key: Pressing the C key opens the door.
2. Insert the insertion rod into the hole in the right side of the door, which is located on the tile floor.
3. When entering the building, first open the glass door on the west side of the hallway, then remove the locking rod on the right side of the automatic door to operate it. After that, simply press the "B" button on the remote control to unlock and use the automatic door normally.
Two. What should I do if the remote control for the electric door lock malfunctions?
1. The remote control is incompatible with the electric door.
Verify that the encoding on the back of the remote control matches the encoding on the back of the receiver. If they do not match, the remote control will not work with the electric door. This situation is relatively rare, and we believe everyone will avoid making this mistake.
2. The remote control transmitter malfunctions.
When the remote control transmitter malfunctions and the power switch is pressed, the indicator light usually does not illuminate. In this case, professional repair is required. If the repair cost is high, the remote control can be directly replaced with a new one.
3. Excessive use of the remote control
An old remote control may no longer respond properly, with some buttons malfunctioning, often due to oil or accumulated dust blocking the contact points between the buttons and the circuit board. To fix this, disassemble the remote, clean it with alcohol, allow it to dry, and then reassemble it. This will restore its functionality.
4. Remote control battery is depleted.
once the remote control's power is depleted, it will stop functioning, which is the most common cause. In this case, a new button battery needs to be replaced. Open the remote control's back cover and insert the prepared button battery, ensuring that the positive and negative terminals are not reversed, to ensure normal operation.