I.Water dispenserHow to install
When installing a water dispenser for the first time, first flush the water tank of the dispenser with clean water. For countertop models, remove the transparent silicone plug at the bottom of the unit to allow water to drain from the lowest point. After cleaning, reassemble the plug. For upright models, both the hot and cold upright dispensers have a screw at the back that can be loosened to drain the water. After use, simply tighten the screw again.
Place the water dispenser in a cool, shaded area and ensure it is level. If using a freestanding water dispenser, ensure the water tank is properly installed and that the bottle holder is correctly attached. For models with integrated water tanks, remove the bottle holder before installation.
When the water in the water heater is not full, do not leave the heating switch on for an extended period, as this can cause the temperature controller with a protective switch installed on the water heater to trip and shut off due to overheating. only turn on the hot water switch when water is flowing from the faucet.
Two. important installation considerations for water dispensers.
After installing the water dispenser, avoid moving it unnecessarily and keep it upright. When installing the water dispenser's bucket, pay attention to the placement of the handles. Many people lift the bucket by its spout and place it directly, which makes it difficult to lift and reposition. When lifting the bucket, place your hands on the top of the bucket to provide support and use leverage to lift it.