1. How to disassemble the lifting mechanism of a computer chair.
1. Turn over and invert the computer chair, remove the base, and use a rubber mallet to firmly strike around the steel ring at the air pressure connection.
2. Then, use the 18mm pipe clamp to firmly grip and bend the pressure rod, allowing you to remove the lower portion of the pressure rod.
3. Similarly, before dismantling part of the air pressure rod, remove the upper seat using a screwdriver.
4. Then, use a rubber hammer to forcefully strike the steel ring around the air pressure pipe connection with a circular motion.
5. After securing the steel ring of the seat, use a 18mm pipe clamp to firmly grip and pull the other end of the air pressure rod to remove it.
Two. What are the tricks for removing the chair gas rod?
1. A hammer is sufficient for removal. First, turn the chair over, then use the left hand to press down on the lifting handle while using the right hand to strike the steel base (specifically at the contact point between the gas rod and the base) with a hammer. Experiment with this method first; it usually works for chairs that haven't been used for a few days.
2. If not, remove the base support, forcefully tap the air column above and below, and at the connection point between the air column and the lower foot to remove it.
3. Boil the water in the kettle and heat it briefly, but avoid burning yourself. It's best to knock it out while the water is still hot.
4. If it's impossible to remove it yourself, we recommend contacting a specialized repair technician to disassemble it, to avoid damaging the computer chair.