One、Why is water used when applying bricks?
"Typically, when installing tiles, we use cement mortar. However, if we use tiles with a high water absorption rate without pre-wetting them, the tiles will absorb moisture from the cement mortar after installation. This can lead to a lack of moisture, causing the tiles to detach, form voids, or even tear."
Two. Should tiles be soaked in water before installation?
Currently, there are two types of tiles available on the market: ceramic tiles and clay tiles. Tiles with higher water absorption rates require soaking before installation, while tiles with lower water absorption rates do not need to be soaked. Therefore, not all tiles require soaking before installation.
Three. Does it require soaking before laying tiles?
Most polished tiles do not require pre-soaking. If you are still unsure, remember: the wall surface needs to be soaked, but the floor tiles do not. However, this is not always the case, so it is best to ask the seller or inspect the tiles yourself before purchasing. If you drip water onto the back of the tiles, you can quickly determine if they are highly absorbent.
Four. How long should tiles be soaked before installation?
Approximately 2 hours. Typically, ceramic tiles should be immersed in water for approximately 2 hours to allow for complete saturation. At this point, the tiles can be removed. However, there is no specific time regulation in the industry for tile soaking. The soaking time depends on the tile type, absorption rate, and other factors. Tiles with a higher absorption rate will require a longer soaking time.
The method for soaking tiles is actually very simple, and most workers are familiar with it. When soaking tiles, it is important to pay attention to the correct method. First, find a large basin and place the tiles flat inside. Fill the basin with water until the water completely covers the tiles. once the tiles no longer bubble, you can remove them and begin laying them. The editor would like to remind everyone that most tile suppliers do not accept returns on tiles that have been soaked, so it is important to use the correct amount of water.