One. Dry Adhesion Method
1. Clean the furniture and ensure the surface is dry.
2. Determine the exact location where the material needs to be applied. Typically, apply one side slowly while using a tool to smooth it out, and simultaneously remove the backing paper from the decorative film.
3. If the graphic is very large, you can also remove the transparent transfer film and the sticker completely and then reapply them. However, be careful not to cause any accidental adhesion.
4. After application, repeatedly scrape and press the surface. Remove the transparent transfer film.
5. Use a utility knife to carefully trim any excess material, tucking it neatly underneath.
Two. Wet-setting method
1. Clean the furniture surface, and evenly apply water to the areas where the furniture will be attached. This will reduce the adhesion of the sticker and make it easier to adjust the position.
2. Determine the exact location where the product needs to be applied. Apply the product slowly, while gently smoothing it with a tool and removing the backing paper.
3. When encountering door handles or anti-scratch strips, cut the material to size and integrate it as needed.
4. Adjust as needed to ensure the graphic's overall position is correct. Then, vigorously scrape away any remaining water and air bubbles. Remove the transparent transfer film.
5. Use a utility knife to cut off any excess material, tucking it inwards to ensure a smooth application.
6. Ensure the moisture in the decorative paper is thoroughly evaporated. If possible, gently heat and dry the paper using a hair dryer or by placing furniture in a cool, air-conditioned environment.